Cytron SmartDriveDuo-10 - MDDS10Cytron SmartDriveDuo 10 MDDS10 SmartDriveDuo10 has the specification of MDD10A which is able to drive two brush motor at 10A each, plus additional smart features of MDS40A. It has the capability to accept RC (Radio Control) signal for mix mode drive, analogue voltage from the potentiometer, PWM from the microcontroller, and even controlled via UART command. the operation modes is configure by the DIP switch on MDDS10. The commonly DIP switch

Pins of Arduino)

Non-linearity: ±3%

13x Inputs

It uses the 5V supply from your InterfaceKit or Hub and steps it up to 12V while simultaneously passing the 0-5V signal from the sensor into the Phidget cable

GPS 4 click carries the L70 compact GPS module from Quectel

The following events can be used to bring the module out of standby-mode:

NFCWorld+ keeps an up-to-date

Bundles the most popular DFRobot Sensors

Widest beam of the HRLV-MaxSonar-EZ sensors

com If you have a technical inquiry about the product

THERMO 5 click communicates with the target microcontroller over I2C interface

Provides 2