Turret254This turret drive has a large slewing bearing for structural support and the ability to pass objects through the middle. The drive gearbox and motor (not included) are positioned on the outside and includes the hardware to be mounted going up or down. The drive pulley is an 8mm bore with 16 teeth and the bearing has a 13. 25 inch bore with 254 teeth. Outline Drawing Installation Instructions Solidmodel (motor down) As of right now, we aren't planning

This actuator really can boost your robot with a total of 64 positions of movement

MAG Encoder Solidmodel Bottom

The hub is 1/2" hex bore and 3/4" wide

Pick desired pulley ratio 22:25 (1:1

Pick flexible couplings when the encoder will be securely mounted

and heavy duty bearing driven by a HTD-5M 15mm wide belt

Next level: Can be used with the Backshafter dual motor assembly

See speed chart to add pulley and belt options

1/4-20 standard threaded post with knurled hand nut

Solidmodel - 775 Motor Up

Mounting plate DXF

and your robot will enable