Metallic materials. Sheet and strip. Hole expanding test1 Scope This document describes a method of determining the hole expansion ratio in metallic sheets and strips with a thickness range of 1,2 mm to 6,0 mm inclusive and a width of at least 90 mm. NOTE This test is normally applicable to sheet metal and is used to assess the suitability of the product for forming flanges.

BS EN 16473 on the requirements for firefighters’ helmets for technical rescue is useful for:

Capture-related terms

including specification

Bulk density is defined as the ratio of mass to volume

circuit integrity under fire) and/or reaction to fire performance (e

Who is PD IEC/TS 62257-6 - Decentralized Rural Electrification Systems operation for

What is BS EN 50131-2-7-1 – Acoustic glass break detectors about

These conductors are more flexible than Class 6 to EN 60228

are identified and collated and an explanation as to what such pressures relate to is given

retention system effectiveness

Anyone using Eurocode 3 and BS 7910

The limit of detection (LOD) is ≤0