Milling arbors for screw-in cutters SK 40 - M10 - 24 - LB5Application: For mounting screw in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Retaining screw for mounting of face mills arbors

The collet clamping Ø range is always up to 0

For retaining screw DIN 6367

Ergonomic Handle of Design

safe clamping of parallel raw and sawn parts

- After mounting

5V AA Batteries * 3 ( Do not use low self-discharge battery )

For the coolant supply through the centre of HSK toolholders

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance8

20mm for over 500mm/20" range

bei Ø 6 – Ø 32 mm = h235

For cleaning internal tapers on machine spindles