End mill holder Weldon BT 40 - 16 - 63Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Further information on the articles included can be found under the respective article number

For DCONWS = 60 only with four fixation screws according to DIN 912

For the storage of tapping quick change adaptors

Battery :1

For the storage of collet chuck

Minimum internal diameter measurement capability of 20mm

Body made of high strength and anodized aluminum

Tool steel

With ball bearing clamping nut

bei Ø 6 – Ø 32 mm = h232

The origin point is retained throughout the life of the battery

Adaptive interface machine direction (ADINTMS): BMT driven turret interface -size BT65A