Tapping chucks for synchronisation BT 40 - M3-M16 - 85 | ER 20Application: For machining centres with synchronous spindle. Note: Synchro tapping chucks compensate synchronisation errors. Minimal length compensation on compression and expansion balances very small pitch differences between synchro spindle and tap, which can cause high frictional forces on the thread flanks. A possible increase of axial force during the tapping process is reduced to a minimum. Suitable for internal coolant. Coolant pressure up to

Bed height H: 0

- Rustproof

which prevents the breaking of taps

Carbide tipped scriber with clamp

From d = 25 on two clamping screws

The base is designed with a thermal heat isolation hand grip

130 x 46 x 15

2 x 53 x 18

For targeted cooling and lubrication on the cutting edge/evacuation of chips

Applicable up to 100 bar

For machining centres with synchronous spindle

For clamping nuts ER-system